Crank & Bottom Bracket Removal & Installation: Campagnolo® Ultra-Torque®

This article will review how to remove and install bottom brackets for Campagnolo® and Fulcrum® Ultra-Torque® cranksets. The service requires the use of the CBP-8 Campagnolo® Crank and Bearing Tool Set.

1

Preliminary Information

The Campagnolo® Ultra-Torque® system integrates both the spindle and bearings into the arms. The cups are installed in the bike without cartridge bearings. The bearings are pressed to the crank spindle. When the cranks are removed, the bearings come with the arms.

2

Crank Removal

The bearings are removed from the bike after the cranks are removed. Begin by removing the retaining clip from the drive-side cup.

Bb Campy Ultra Torque Cup Clip1

Remove retaining clip from cup

Remove the crank bolt. NOTE: for Super Record™ cranks, the bolt is a left-hand thread and removes clockwise.

Bb Campy Ultra Torque Loosen Crank Ccw

Loosen counterclockwise for non-Super Record™

Bb Campy Ultra Torque Loosen Crank Cw

Super Record™ loosens clockwise

If removing the crank only, such as for cleaning or internal routing, the process of removal is done. Skip to crank installation.

3

Bearing Removal

Each arm has a pressed cartridge bearing. The right side has C-clip that must be removed before the bearing can be pulled. A small, flat tipped screwdriver can be worked under the edge on the clip to pry it free from the groove in the spindle. Work the C-clip up and off the spindle.

Bb Campy Ultra Torque Spindle Bearng Clip

Remove C-clip from spindle

The CBP-8 uses a bearing puller consisting of two fingers to engage the bearing and a driver to pull it upward. Arrange the bearing puller assembly over the spindle. Use the side knobs to snug the fingers under the bearing.

Use a wrench to turn the driver clockwise. This pushes the tool plunger against spindle end and pulls the fingers and bearing away from the crank.

Repeat on the other arm.

Bb Campy Ultra Torque Cpb 8 Pulling

Engage bearing puller under edge of bearing

Bb Campy Ultra Torque Cpb 8 Pulling2

Turn driver to pull bearing off spindle

4

Bearing Installation

Install any crank seals that were removed. Grease the pressed surfaces and place a new bearing on the spindle.

Place the bearing driver from the CBP-8 over the bearing and strike downward with a hammer.

Engage C-clip over the right spindle end. Use bearing driver to push by hand until clip engages groove in spindle.

Bb Campy Ultra Torque Cpb Driverbearing

Drive bearings down until fully seated

Bb Campy Ultra Torque Cpb Driver Clip Push

Use installer to push C-clip into place

5

Crank Installation

Install the wave washer onto the left bearing.

Bb Campy Ultra Torque Wave Washer

Install wave washer on left arm

The cranks with bearings are now pushed back into the cups. Align cranks straight. Grease crank bolt and tighten to manufacturer’s recommendation.

Bb Campy Ultra Torque Record Tighten

Secure crank