Park Tool has issued a Stop Use and Inspect Notice for their CCP-22, CCP-44 and CWP-7 crank pullers due to an out-of-spec nut that is shared between the three tools. This out-of-spec threading can cause damage to bicycle cranks during removal. Some, but not all, tools sold between October 2021 and April 2022 may be affected.
PART NUMBER AFFECTED: Park Tool CCP-22, CCP-44 and CWP-7 Crank Pullers.
MANUFACTURED DATE: If you purchased one of these tools between October 2021 and April 2022, it may be affected.
INSPECTION OF TOOL: To see if your tool is affected, locate the nut on each of the tools per the images below and inspect the threading.
Bad threads will have a flat peak, and the improper thread peaks will extend almost halfway down the threading of the nut. The non-affected tools have sharper and consistent thread peaks throughout the length of the nut, as shown in the picture.
Please fill out the form below and Park Tool will replace the nuts with bad threads at no cost.