Repair Help

Find Repair Help by searching, selecting categories, or clicking on the "View Bike Diagram" button (Tablet or Desktop).

1-10 of 16 Articles Found

Guide to Chain Tool Pin Replacement Video

This article will outline the proper usage of our chain tools, as well as the pin replacement process. Park Tool chain tools are designed to provide years of use for the professional and home mechanic. With proper use, the chain tool pin should also last a long time - however, it can break due to fatigue or improper use. The pin is replaceable and is available from your local retailer or from

TS-2.2 and TS-2 Centering Video

This article will discuss the centering procedures for the TS-2, TS-2.2, and TS-2.2P Professional Wheel Truing Stands. The same procedures and concepts apply to all stands.

Beam-Type Torque Wrench Use

This article will discuss the use of beam-style torque wrenches such as the TW-1.2 and TW-2.2, as well as the TW-1 and TW-2 (both discontinued).

TS-2 & TS-2.2 Rebuild Kit Installation Video

This article will discuss the installation of the TS-RK rebuild kit into TS-2 & TS-2.2 Truing Stands.

PFP-6 and PFP-3 Service

This article will discuss the service of the PFP-6 Home Mechanic Floor Pump and the PFP-3 Floor Pump (both discontinued).

PFP-4 and PFP-2 Service

This article will discuss the service of the PFP-4 and PFP-2 Professional Floor Pump (both discontinued).

CBP-3 Puller Repair

This article will review the replacement of the pulling caliper finger part #1193-2 on the CBP-3. Bearings and cranks that are seized in place may exceed the strength of the caliper and this may cause the caliper to fail.

1951-15 Adaptor Stud Installation for PRS-15

This article demonstrates how to disassemble your PRS-15 repair stand to replace the original 100-15X clamp with the 100-25D micro-adjust clamp using the 1951-15 adaptor stud.

Guide to Replacement Clamp Covers

This article will review the replacement jaw covers available for Park Tool repair stands. There are several jaw covers available depending upon the model and generation of your stand. It is best to inspect your clamp and then compare it to the jaw covers here. All jaw covers come as a complete pair with fasteners if applicable.

CN-10 Cable Cutter Adjustment Video

This article will discuss the adjustment of the CN-10. There have been several generations of the CN-10, and the concepts below apply to all.

Filter by Category