Repair Help

Find Repair Help by searching, selecting categories, or clicking on the "View Bike Diagram" button (Tablet or Desktop).

1-10 of 15 Articles Found

PFP-2 Pump Recall

Park Tool Company has discovered a defect in a small percentage of PFP-2 Professional Floor Pumps.

CBP-3 Puller Repair

This article will review the replacement of the pulling caliper finger part #1193-2 on the CBP-3. Bearings and cranks that are seized in place may exceed the strength of the caliper and this may cause the caliper to fail.

TS-RK Installation

This article will discuss the installation of the TS-RK rebuild kit into older TS-2 Truing Stands.

1951-15 Adapter Stud Installation for PRS-15

The #1951-15 is a threaded stud that will allow the 100-25D to fit the PRS-15 repair stand. NOTE: The clamp will not fold downward as the original 100-15X clamp design.

The #1951-15 adapter stud works only in the PRS-15 with the three-pointed knob behind the clamp, as seen on the top tube in image #1. See note at end of article for models with a different top tube handle.

100-4X, 100-15X & 100-6X, and PRS-15 Service

This article will discuss the service of the 100-4X and 100-15X Extreme Range Clamps. The 100-4X fits into the PRS-2, PRS-3 and PRS-4 Repair Stands. The 100-15X clamp is used on the PRS-15 repair stand. The common service of these clamps it to lubricate the moving parts. Instructions here are written assuming the clamp is positioned so the jaws are horizontal to the ground.

Torque Wrench Use

This article will discuss the use of beam-style torque wrenches such as the TW-1 and TW-2 (both discontinued).

PCS-10 Assembly

This article will discuss the assembly and use of the PCS-10 Home Mechanic Repair Stand.

DC-1 Digital Caliper Use

This article will discuss the use of the Park Tool Digital Caliper DC-1. The DC-1 will measure outside diameter, inside diameter, and depth. The caliper uses a digital read-out that will turn on when the jaws are opened.

CN-10 Cable Cutter Adjustment

This article will discuss the adjustment of the CN-10. There have been several generations of the CN-10, and the concepts below apply to all.

Guide to Replacement Clamp Covers

This article will review replacement jaw clamp covers. There are several clamp covers available depending upon the model and generation of your stand. It is best to inspect your clamp and then compare to the clamp covers here. All jaw covers come as a pair. Jaw covers are listed here in reverse numerical order.

Next Page
Filter by Category