This article will review the replacement of the pulling caliper finger part #1193-2 on the CBP-3. Bearings and cranks that are seized in place may exceed the strength of the caliper and this may cause the caliper to fail.
1
Repair
Figure 1. CPB-3 puller
Begin by removing the pin from the cross member (figure 2). Use a small punch to drive the pin out one side on the side plate.
Figure 2. Drive pin from cross member
Center cross member over an open vise to all pin to pass out of back side of cross member (figure 3).
Figure 3. Use vise to support cross member
Drive pin far enough to allow caliper to be removed (figure 4). Install new caliper in cross bracket in place of old caliper.
Figure 4. Caliper part #1193-2 can now be replaced
Support cross member over vise and tap pin back into place (figure 5). Tool is ready for use.
Figure 5. Reinstall pin into cross member and though caliper hole
