Campagnolo and Fulcrum Ulta Torque Bearing Service
CBP-3 Bearing Puller for
Campagnolo and Fulcrum Crankset Bearing Service
This article will review the bearing service of the Campagnolo and Fulcrum Ultra Torque cranksets. The service requires the use of the CBP-3 Bearing Puller Set. For crank installation and removal see Campangolo Ultra Torque Service.
The Campagnolo system integrates both the spindle and bearings into the arms. The cups are installed in the bike without cartridge bearings. The bearings are pressed to the crank spindle. When the cranks are removed, the bearings come with the arms (figure 1).
Figure 1. Left crank, cartridge bearings, "wavy washer" and bottom bracket cup
The cartridge bearings can be removed and new bearings installed. Begin removal by inspecting both arms for a C-clip above the bearing. NOTE: This C-clip must be removed before the bearing can be removed. Use snap ring pliers when available. A small flat tipped screwdriver can also work. Catch the edge on the clip and pry it free and up from the groove in the spindle (figure 2). Work the C-clip up and off the spindle (figure 3).
Figure 2. ANY C-CLIP MUST BE REMOVED BEFORE ATTEMPTING TO PULL BEARING
Figure 3. Pull upwards on the C-clip and remove it from the spindle.
The CBP-1 consists of a plunder system with two fingers to engage bearings. Arrange the CBP-1 bearing puller assembly over the spindle. Use the side knobs to snug the fingers under the bearing (figure 4).
Figure 4. Engage puller over bearing after removing the C-clip
Turn handle clockwise. This pushes tool plunger against spindle end, and pulls fingers and bearing away from crank (figure 5 and 6).
Figure 5. Turn handle to pull bearing
Figure 6. Bearing will pull upward toward end of spindle
The bearings should be replaced if removed. New bearing must be pressed back onto spindle with an interference fit. Replace any seals that were removed on the crank. Install bearing over spindle and drive CBP-2 race installer downward by striking with a hammer (figure 7). The CBP-2 is a precise fit to the inner bearing race and will not damage bearing surfaces.
Figure 7. Drive CBP-2 and bearings down until fully seated
Any C-clip that was removed must now be re-installed. Enagage C-clip over spindle end. Use CBP-3 to push bearing down until bearing engages groove in spindle (figure 8).
Figure 8. Use CBP-2 to push C-clip into place
Install cranks as with normal Ulta Torque service.